- Service interval function
- 7 day, 5/2 day or 24 hour programming
- Permanent back lit display
- AM/PM or 24 hour display
- Built-in programmes
- Automatic BST/GMT time change
- Convenient user overrides
- Holiday function
- Industry standard wallplate
- Factory set clock


The CP715 Si two-channel, common time base programmer has separate Heating and Hot Water outputs, allowing either service to run independently of each other, but sharing a common time base.

The CP715 Si can be configured by the installer at time of installation to provide 7 day, 24 hour, or 5 day/2 day operation and either 2 ON/OFF's or 3 ON/OFF's per day, allowing the time control to be tailored to match the specific requirement of the consumer.

Additionally the programmer can be set for either 'pumped' or 'gravity' hot water.

The wallplates used follows the industry standard pattern, as used by many of the other time control manufacturers. This allows for direct replacement often without the need for re-wiring.

An additional range of accessories allow the CP715 Si to be used in other upgrade situations where the unit being replaced is larger than the new unit and a decoration scar would normally have been left.

Additional features such as service interval timer, convenient user overrides, built-in ready-to-use programmes, a day programme copy facility as well as a stylish, compact design and easy to read display make the CP715 Si the simple answer to all heating and hot water requirements.